Huawei Network Products One Stop Shopping, Global Delivering.
| | |
How to configure a 10G GPON service board
Related Articles

How to configure a 10G GPON service board

Topcis:
,

This section describes how to configure a 10G GPON service board.

 

Adding a Board

You can add a 10G GPON service board using either of the following methods:

Manually inserting a board: When 10G GPON boards have been configured in the subrack, manually insert a required board.

Adding a board offline: When a 10G GPON service board needs to be pre-configured, add a 10G GPON service board offline.


NOTE:

In global config mode, run the board add frameid/slotidboard-type command to add a 10G GPON service board.

After a board is successfully added offline, the board status is Failed. However, you can still configure or query data on the board.

After a user manually inserts a board (the board type must be the same as that of the board added offline), the board status changes to Normal. Data configured for the board takes effect immediately after the configuration.


Configuring the Working Mode of a Board

Configure the working mode of a 10G GPON service board based on actual requirements. The PON system supports the following modes:

GPON mode

XG-PON mode, that is, 10G GPON mode


Commands related to the working mode of a 10G GPON service board are as follows:

In diagnosis mode, run the display gpon board workmode command to query the working mode of a 10G GPON service board.

In diagnosis mode, run the gpon board workmode command to configure the working mode of a 10G GPON service board.


NOTE:

A 10G GPON service board works in XG-PON mode by default.


You have added

to your shopping cart

How to configure a 10G GPON service board
How to configure a 10G GPON service board
Topcis:
,

This section describes how to configure a 10G GPON service board.

 

Adding a Board

You can add a 10G GPON service board using either of the following methods:

Manually inserting a board: When 10G GPON boards have been configured in the subrack, manually insert a required board.

Adding a board offline: When a 10G GPON service board needs to be pre-configured, add a 10G GPON service board offline.


NOTE:

In global config mode, run the board add frameid/slotidboard-type command to add a 10G GPON service board.

After a board is successfully added offline, the board status is Failed. However, you can still configure or query data on the board.

After a user manually inserts a board (the board type must be the same as that of the board added offline), the board status changes to Normal. Data configured for the board takes effect immediately after the configuration.


Configuring the Working Mode of a Board

Configure the working mode of a 10G GPON service board based on actual requirements. The PON system supports the following modes:

GPON mode

XG-PON mode, that is, 10G GPON mode


Commands related to the working mode of a 10G GPON service board are as follows:

In diagnosis mode, run the display gpon board workmode command to query the working mode of a 10G GPON service board.

In diagnosis mode, run the gpon board workmode command to configure the working mode of a 10G GPON service board.


NOTE:

A 10G GPON service board works in XG-PON mode by default.


Related Articles